Eastman - Adhesives & Sealants Market

Manage Profile

FAQs


		Contact

Use the filters below to refine your selection.

Select Category:


General

	What plasticizer is used widely in adhesives?
	Are Eastoflex amorphous polyolefins soluble in organic solvents?
	How can plasticizers be used as emulsion modifiers for adhesives?
	How can the peel adhesion and probe tack properties of pressure-sensitive adhesives based on amorphous polyolefins be improved?
	Are there any substitutes for polyisobutylene (PIB) in pressure-sensitive adhesives?
	What is Eastman triacetin, and how is it used?
	How much tackifier should be used when formulating packaging adhesives with polyethylene polymers?
	Can rolling-ball tack properties of SIS (styrene-isoprene-styrene) based pressure-sensitive adhesives be improved by increasing the tackifier concentration?
	How can loop tack and quick stick properties of SIS (styrene-isoprene-styrene)-based pressure-sensitive adhesives (PSAs) be improved?
	What is Eastman Inhibitor OABH, and how is it used?
	What is the physical form of Eastman Inhibitor OABH, and what are some characteristics?
	What are some ways to improve the shear adhesion failure temperature (SAFT) and shear properties of SIS (styrene-isoprene-styrene)-based pressure-sensitive adhesives (PSAs)?
	How can probe tack of an SIS (styrene-isoprene-styrene) based pressure-sensitive adhesives (PSAs) be improved?
	How can elevated temperature shear properties of a natural-rubber based pressure-sensitive adhesive be improved?
	How can solid sulfonated polyester (pellets) be dispersed?
	What construction material is suggested for tank storage of Eastman solvents?
	Which solvent borne adhesion promoters are recommended for use as stir-in additives to paints, inks, or adhesives?
	What is the difference between Eastman DUP (unstabilized) and Eastman DUP-CA (stabilized)?
	What are some end uses of highly sulfonated polyesters?
	An attempt was made to disperse sulfonated polyester pellets in hot water, but the material clumped up. How can I correct this problem in the future?