Jennifer Cogar, Architectural Coatings Global Application Development Scientist,, will present a paper,
Development of Novel Additives to Extend Open Time in Low VOC Aqueous Coatings, at the Coatings Trends and Technologies conference, September 13-14, Oak Brook, IL. The paper discusses the challenges achieving an acceptable balance of properties both during the film application and drying process as well as in the final film when formulating waterborne coatings. The paper was selected as a best paper award finalist.
Conference Website |
|
Development of Novel Additives to Extend Open Time in Low VOC Aqueous Coatings
Jennifer Cogar
Eastman Chemical Company Research Laboratories, P.O. Box 1972, Kingsport, TN 37662-5150
One of the challenges of formulating waterborne coatings is achieving an acceptable balance of properties both during the film application and drying process as well as in the final film. This difficulty is compounded by regulations relating to the reduction of volatile organic compounds (VOC) and guidelines regarding emissions of architectural coatings. There is a competition between the requirements for adequate workability time of the coating with appropriate film formation and recoat behavior. The period in which irregularities in a freshly applied coating can be repaired without resulting in brush marks is referred to as the
open time, while the period in which a coating can be applied over an existing paint film without leaving lap marks is deemed the
wet edge time. Aqueous coatings generally employ dispersed high molecular weight polymers as binders, which often results in short open times when the coating is dried since the dispersed polymer particles tend to coalesce quickly in the edge region of an applied coating. As a result, the viscosity of the coating increases rapidly, which leads to a limited window of workability. Small molecule alkylene glycols are routinely incorporated in aqueous coatings as humectants, but are limited in utility since they are considered to be VOCs. This paper describes the process by which new, low VOC additives were developed to improve open time and wet edge in low VOC aqueous coatings. Mechanisms for the enhanced performance will be outlined through use of novel rheological and thermal analysis techniques. Paint performance properties will be exemplified in a typical architectural formulation.